PROJECTOR (FRONT VIEW)
Fan grille
Keystone 
Lens
button: Push this button to turn the projector on when it's in
MENU button: Push this button to open the menu.
/ 
/ 
/ 
buttons: Use these buttons to navigate through the menu.
PC/AV button: Use this button to select the video source you want to use. You can select between signals like PC, VCR or DVD. The beamer will switch between video sources every time you push this.
LED indicator: Put the projector into
Fan grille: Cool air inlet.
Focusing the image by turning the lens.
PROJECTOR CONTROL
Remove the lens cap after connecting the mains cable.
1. Insert 2 batteries in the battery compartment.
2. Turn the On/Off switch to "ON"; the LED will flash slowly.
3. Push the "ON" button on your remote or the one on the projector. The LED will light up red.
4.Hold one of these buttons for 2 seconds. The lamp will 
2 minutes the image appears on the projector screen.
5.Focus the image with the lens and setup the size and position of the image. You can correct the Keystone if necessary.
6.Setup the required image quality with the OSD menu.
7.Push the "ON" button again and the lamp will switch off.
8.The LED will flash rapidly and the fans will keep operating for around 5 minutes to cool the projector. Do not turn the projector on again during this period!
MAKING CONNECTIONS
The sockets for making connections on the back panel of the projector are shown below:
Video input: Connect with a composite output signal from a video device.
Audio input: Connect with an audio signal from a video or audio device.
VGA input: Connect with a computer output signal.
RF input: Connect the antenna of the wired television.
AC Power Switch:Turn the projector on or off. When using Remote Control Unit, turn the switch to ON. And turn it to OFF when the projector is not used.
Here is a 5 Amps fuse installed for the projector.
AC Power Jack: Connect AC Power
Cable (supplied) to the projector.
IR receiver
10 | 7 |
