PYLE Audio PSW115 manual Attach mount to wall, Wooden wallFig 2b, Attach bracket to TV

Step 2: Attach mount to wall

First, determine the height of stand

The best height of stand is parallel to eyelevel of a person who sitting on a couch. Normally, the horizontal distance of eyelevel is about 4’ from ground level.

The following two conditions are for determining the perfect height of stand:

1) the distance between wall and couch(Fig 2a).

2) the distance of eyelevel from ground level plus the distance measured from eyelevel of a person sitting on couch with viewing angle of 15°(Fig 2a).

For example:

1) the distance of ‘a’ is 5’-7’, the distance of ‘b’ is about 1’

2) the distance of ‘a’ is 8’-13’, the distance of ‘b’ is about 3’

3) the distance of ‘a’ is 14’-17’, the distance of ‘b’ is about 4’

The perfect height of stand centre will be anywhere within b, where you feel comfortable for viewing.

15 degree	b
viewing angle

eyelevel

a

Fig 2a

After determining the height of stand, follow the installation instructions in below to install wall mount to different kinds of wall -wooden, brick, concrete and stone.

Wooden wall(Fig 2b):

Us i n g a a w l o r n a i l t o m a k e where the nails are located, as shown as fig.2b. Pre-drill these holes with a 5mm drill bit to at least 80mm in deep hole. Please make sure these holes are level and located at center. Use wall mount as a template to mark the location of other three holes and drill the same holes. Fix the wall mount to the wall with 4 long bolts(I) and washers(K).

WARNING

We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use of this product.

Note: The supplied wall mounting hardware is not for use on steel stud walls or cold cinder block walls. If you are uncertain about the nature of your wall, please consult a qualified contractor. If the hardware you required is not included please contact your local hardware store.

Step 1: Attach bracket to TV

Check your TV manual to confirm the diameter of bolt to be used or choose a

appropriate bolts according to size, height and position of the holes on your TV. See pages 4-5 of these instructions for examples.

For correct installing, make sure that hook of ever y bracket must facing down. Use selected bolt, spacers and washer for installing bracket a t t h e b a c k o f d i s p l a y. A d j u s t t w o b r a c ke t s t o e q u a l h e i g h t s a n d level. Once aligned, tighten up the bolts securely.

IMPORTANT: Don't force the bolt into the hole, which will cause a damage of equipments and injure of person. Don't use electric drill to fasten any bolts.

-6- -3-