Parts: |
|
|
| Letter |
| Qty | Description | |
2 | 1 |
|
|
| ||||
|
|
|
|
|
|
| ||
|
|
|
| 1 |
| 1 | Monitor Plate | |
|
|
|
| 2 |
| 1 | Wall Plate | |
|
|
|
| 3 |
| 2 | M5x10 Safety bolt | |
|
|
|
| A |
| 4 | M4x8 bolt | |
|
|
|
| B |
| 4 | M4x12 bolt | |
|
|
|
| C |
| 4 | M5x8 bolt | |
|
|
|
| D |
| 4 | M5x12 bolt | |
|
|
|
| E |
| 4 | 1/ | |
|
|
|
| F |
| 6 | M5 washer | |
|
|
|
| G |
| 4 | M6 washer | |
| 3 |
|
| H |
| 2 | Long bolt | |
|
|
| I |
| 2 | Wall anchor | ||
|
|
|
|
| ||||
A | B | C | D | E | F | G | H | I |
Step 1
Determine the desired location for the monitor.
Important: Make sure there is adequate mounting space available for the monitor, considering the monitor dimensions. This mount is supplied with the necessary hardware for either Wooden Stud Mounting or
Masonry Mounting. DetermineFig 1 your mounting type and proceed accordingly.
Step 2
Wooden Stud Mounting:
Using an electronic stud finder, locate the center of the wooden stud. Position the Wall Plate (2) in desired mounting location over stud. Level the Wall Plate with a bubble level, and then using the wall plate as a template, mark mounting hole locations over the center of the stud. Drill 2 mounting holes 50mm deep, into the stud using a 3mm drill bit.
Masonry Mounting:
Position the Wall Plate (2) in desired mounting location on wall. Level the Wall Plate with a bubble level, and then using the wall plate as a template, mark mounting hole locations on wall.
Drill 2 mounting holes 50mm deep, using a 8mm masonry bit. Insert Wall Anchors (I) into the mounting holes, and lightly tap them flush to the wall with a hammer.
Caution: Wall Anchors should only be used for masonry mounting. NEVER use wall anchors to mount the mount to drywall.
Securely mount Wall Plate with supplied Long Blot (H) and washer(F). Step 3
Attach Monitor Plate to back of the monitor with 4mm , 5mm or
Caution: Never force screws into the monitor, as damage may occur.
| G | E |
|
| |
F | A,B,C,D, |
|
Fig 2
