PYLE Audio PWLB008 manual 4102mm）

I

G,H

1 A-F

Fig 4

Step 4

Carefully position monitor so that Wall Plate and Monitor Plate are vertically aligned, with the bottom of Monitor plate overlapping the top of the Wall Plate.

Gently lower monitor into position, sliding the two plates together until the Monitor Plate bottoms out against the Wall Plate. (Fig. 5)

Caution: Make sure that the plates are engaged on both sides of the mount before releasing grip on monitor.

1

	2
Step 5
Thread two Safety Screws (3) through bottom of
Wall Plate and into Monitor Plate, to secure the	3
assembly. (Fig. 5)

Fig 5

Step 1

Determine the desired location for the monitor.

Note: When mounting to wooden studs, the Wall Plate can be offset up to 2” in either direction from stud center (+/-2”) by utilizing the offset mounting holes. ( Fig. 1)

Important: Make sure there is adequate mounting space available for the monitor, considering the monitor dimensions.

The mount is supplied with the necessar y hardware for either Wooden Stud Mounting or Masonr y Mounting. Determine your mounting type and proceed accordingly, as shown on next page.

4"(102mm）

+2" -2"

Fig. 1

	-3-
-6-