Mixing the Inputs, cont.

4.Set the Channel A and Channel B volume control sliders to approximately 8-10.

5.Rotate the Master Volume Control clockwise until you observe an average reading of “0” (zero) on both Output Level LED meters, and leave it at that setting. (Please note that the Output Level LED meter indicates the total output signal being mixed from all sources for each of the Left and Right channels.)

6.When adding an audio input source to the mix, adjust the corresponding Channel A and B volume control sliders so you maintain the average reading of “0” on both Output Level LED meters.

7.Adjust the receiver/amplifier volume control (not the mixer’s) to the desired volume.

8.To turn off the mixer, push the Power switch to the OFF position; the Power LED will be extinguished.

Input Source
Volume Control Sliders

Using the Crossfader

When the crossfade slider is in the center position, the two assigned channels play equally. Sliding the control towards the A position will increase the level of A and fade out B proportionally to the distance from center. Likewise, sliding the control towards the B position will increase the level of B and fade out A.

Crossfader

Control

Using the Tone Controls (PYD-720)

To enhance the sound or tailor the highs, mids

Using the Microphone

Incorporating Voice into the Mix

To blend voice from the microphone with the audio program material, adjust the MIC level slider to increase or decrease the microphone level. This will not affect the main volume inputs. When the microphone is not in use, set the MIC level slider to “0.”

PYD-710

Microphone Level
ControlPYD-720

Talkover Mode (PYD-720)

When mixing the mic into the mix, you would usually leave the Talkover switch in the ON position. In special situations, however, the PYD-720’s Talkover mode allows a voice to be heard clearly through the microphone by attenuating all the other audio input sources.

This mode is engaged by setting the Talkover Switch to the TALKOVER position. When not using the microphone, set this switch to the OFF position.

and low frequencies for each audio source input to the acoustics of a particular performance environment, you can adjust the BASS and TREBLE tone controls.

Tone Controls

Using the Master Level

Control

The overall volume of the mix of all inputs is adjusted using the Master Level control.Turning this control clockwise increases the overall system volume.

Master Level

Control

Talkover Switch

PYD-710

PYD-720

6 – Pyle Pro Mixer Owner’s Manual

Pyle Pro Mixer Owner’s Manual – 7