OPERATING PROCEDURES
Before starting operation
Check that the controls have been set to the following positions before commencing operation
Rotate the VOLUME control counterclockwise as far as it will go and set it at the “0” minimum volume position. Set the BALANCE control to its center position.
Set the BASS and TREBLE tone controls to the “0” (center) position.
After these checks, press the POWER switch to turn on the power.
If you find a remote standby indicator is lighted, the power amplifier is in remote standby mode.
(a)Press the power switch off and press it once again after the remote standby indicator is off.
(b)Using the remote control to switch on the power.
After switching on, the indicator will be shinning on “Phono” for a second, after that the unit is set to “Tuner”.
Playing a program source
1.Press the desired input selector switch to select the program source to which you wish to listen. To listen to record: press the PHONO switch.
To listen to radio broadcast: Press the TUNER switch.
To listen to a compact disc: Press the CD switch.
To listen to a component connected to VIDEO terminals: Press the VIDEO switch.
To listen to a component connected to AUX terminals: Press the AUX switch.
To listen to a tape: Press the TAPE switch. 2.Operate the program source unit.
3.Gradually turn the VOLUME control clockwise until the desired volume level is obtained. 4.Attain a balance between the sound of the left and right channels using the BALANCE control. 5.To adjust the tone quality, adjust the BASS and TREBLE control.
RECORDING TAPE
A record, compact disc, broadcast of the program source of a component connected to the line terminals can be recorded by the tape deck connected to the TAPE recording (REC) terminals.
1.Select the input selector switch corresponds to the program source (Phono, CD, Tuner, Video/Aux) which is to be recorded.
2.Start playing the program source.
3.Operate the tape deck and press the “REC” key.
*The volume, Balance, Tone and other controls (including graphic equalizer) have no effect on the recording level or sound quality of the signals being recorded even they are operated.
MICROPHONE MIXING (KARAOKE)
-Connect the microphone to MIC jack.
-Adjust your desired singing voice level with Karaoke by turning the MIC LEVEL switch.
**Note**
-If strange noises (squealing or howling) are emitted during mixing, change the direction of the microphone or turn down the volume.
-It is possible to record a singing voice accompanying the CD, Tuner, Cassette Tape or Video.
-If using microphone or with Karaoke, it is better to switch off the sound effect switches and adjust the treble/bass volume to zero.
-If using remote to switch off the power Amplifier, the Remote Standby Indicator will be grown on. At this state the amplifier is in sleep mode only, the transformer and parts of circuit is in operation with low energy.
Switch off the Power Amplifier by pressing the main power switch in case of long absence.
5
