Installation Instructions
This Quick Start Guide describes how to install and configure your new QLogic SANbox 6140 Router by following these steps:
❑Step 1. Verify the package contents.
❑Step 2.
❑Step 3. Mount the router.
❑Step 4. Install the SFPs.
❑Step 5. Apply power to the SANbox 6140 router.
❑Step 6. Install the SANsurfer® Router Manager.
❑Step 7. Configure SANbox 6140 management port IP address.
❑Step 8. Run the configuration wizard.
❑Step 9. Presenting LUNs to iSCSI initiators
Step 1. Verify the Package Contents
The QLogic SANbox6140 Router is shipped with the following items:
❑SANbox 6140 Router (1)
❑Small Form Factor Pluggable (SFP) transceivers (2)
❑AC power cord (1), CD (1), and Serial adapter (1)
Optional equipment:
❑Shelf for Rack Mount
Step 2. Pre-installation Checklist
During the initial configuration process, the user will be requested to input the following parameters. Please write down the IP addresses in the space provided.
Parameter | Value |
|
|
Symbolic Name of this SANbox 6140 |
|
|
|
IP address (if not using DHCP) for the management |
|
port in the SANbox 6140 |
|
|
|
IP address, subnet mask & gateway (if applicable) |
|
for the GE 1(iSCSI port 1) |
|
|
|
IP address of the iSNS server for iSCSI Port 1 |
|
(if iSNS will be enabled) |
|
|
|
IP address, subnet mask & gateway (if applicable) |
|
for the GE 2 (iSCSI port 2) |
|
|
|
IP address of the iSNS server for iSCSI port 2 |
|
(if iSNS will be enabled) |
|
|
|
2
