Q-See QSD004C4-250 manual Motion Set, Motion SET Motion Record Time

QSD004C4-250 User’s Manual

5.14 Motion Set

MOTION SET
MOTION RECORD TIME:		10
MOTION ALARM TIME:		OFF
MOTION SET
PRESS (UP, DOWN),	ENTER (SELECT)
PRESS (MENU) TO	EXIT

MOTION SET:

MOTION RECORD TIME:

This number indicates how many seconds the motion detection recording continues after a motion triggered event ends.

MOTION ALARM TIME:

This number indicates how many seconds the buzzer inside the DVR will sound after the DVR has been triggered by motion.

CONT: Continuous alarm until any key is pressed to stop.

OFF: No alarm

MOTION DETECTION SET

>CHANNEL 1 SENSITIVITY 4 CHANNEL 2 SENSITIVITY 4 CHANNEL 3 SENSITIVITY 4 CHANNEL 4 SENSITIVITY 4

CHANNEL 1 AREA SET

CHANNEL 2 AREA SET

CHANNEL 3 AREA SET

CHANNEL 4 AREA SET

PRESS (UP, DOWN),	ENTER (SELECT)
PRESS (MENU) TO	EXIT

AREA SET:

SENSITIVITY:

Use [Up] and [ Down] button to select the channel you want to modify, press

[SEL] to adjust sensitivity of motion detection on each channel.

High (1---------- 9, OFF) Low

When it’s “OFF”, the channel cannot be triggered by motion.

Use [Up] and [ Down] buttons to select the channel you want to modify, press [SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press[Up] and [ Down] to move the cursor up and down, press [SEL] to set the block active or not.

When the block is transparent, it’s active to record. When the block is covered by shadow, it is not active, and motion in this area will NOT be detected.

Make sure Record Schedule is set to Motion for the times required.

- 11 -