SECTION 4: SETTING UP DMZ IN ROUTER 2
NOTE! You will only need to proceed with this section if you detected a second router in Section 2.
STEP 1. Login into Router 1 by putting the IP of Router 1 into the Internet Explorer browser, as in the example shown in Picture 23 where the IP address of Router 1 is 192.168.0.1
STEP 2. Find the status page on the router settings that shows the WAN/ Internet IP address and write it down this WAN IP address.
STEP 3. Log into the Router 2 by putting
the IP of Router 2 into the Internet Explorer browser, as in example shown in Picture 23 where the IP address of Router 2 is 192.168.1.1
STEP 4. Find the DMZ page in the router
settings. |
|
STEP 5. Enter the WAN IP for Router 1 |
|
into the DMZ page and enable DMZ. | PICTURE 23 |
|
NOTE! If you do not have a DMZ setting in the router, check to see if there is a Bridge setting. If so, then use the Bridge setting instead of DMZ.
STEP 6. Save your changes.
You have forwarded the ports on the router to which the DVR is connected, to the IP address of the DVR, and set the primary router to pass the connection to this router.
