Vertical Suspension of the HPR152i and HPR153i loudspeakers
Install Two Top Surface Eyebolts
1- On the top front corners of the enclosure, locate the rubber inserts which pro- tect the enclosure’s threads. Remove the rubber inserts.
2- Place one conical spring washer and one eyebolt standoff onto the threaded portion of an eyebolt and carefully thread the eyebolt assembly into the enclo- sure’s threads. Repeat for remaining front, top corner.
•Note! Be sure to tighten each eyebolt until shoulder is snug against the spring washer and each eyebolt standoff is snug against the enclosure. Tighten the eyebolts down and then continue to rotate until they are positioned as desired.
Install One Pull-back Eyebolt
At the rear of the enclosures, just below the amplifier module is a M10
1- Remove the factory installed bolt using a 6mm hex wrench.
2- Thread an eyebolt into the enclosure’s threaded insert; do not use a flat washer or an eyebolt standoff on the
•Note! Be sure to tighten bolt until shoulder is snug against the side of the enclosure. Tighten the eyebolt down and then continue to rotate until it is positioned as desired.
•Do not suspend the HPR152i or HPR153i loud- speaker horizontally under any conditions! The HPR152i and HPR153i loudspeakers are designed for vertical suspension only!
© Copyright 2007, QSC Audio Products, Inc.
QSC® is a registered trademark of QSC Audio Products, Inc.
“QSC” and the QSC logo are registered with the U.S. Patent and Trademark Office All trademarks are the property of their respective owners.
*TD-000249-00*
Eyebolt installation locations for HPR152i and HPR153i loud- speakers.
Before installing the eyebolts, remove the rubber inserts protecting the enclosure’s threads (HPR152i
and HPR153i only).
Rubber insert removal (HPR152i and HPR153i only); gently pry upward to loosen insert.
Eyebolt standoff installation, HPR152i, HPR153i.
Installed eyebolt.
