Outputs
The PLX 1104 and PLX 1804 models are equipped with Speakon output connectors for each channel. PLX 1802, PLX 2502, PLX 3102, and PLX 3602 models are equipped with Speakon and binding post output connectors.
Wiring connections are shown on the back of the chassis. Carefully note the markings and maintain consistent loudspeaker polarity for optimum system performance.
Speakon Output Connectors
If making Speakon cables, be sure to connect the loudspeaker wiring as shown on the chassis. Channel 1’s Speakon provides
Stereo and Parallel Mode: Connect each loudspeaker to its own chan- nel of the amplifier, as shown on the chassis label. The INPUT CONFIGU- RATION switch must be set for STEREO or PARALLEL mode.
Bridge Mode (PLX1802/2502/3102/3602 models only): Use Channel 1’s Speakon for Bridge mode output connection. Bridge mode configures the channel pair to drive a single
Binding Post Connectors (PLX 1802/2502/3102/3602 models only)
Stereo and Parallel Mode: Connect each loudspeaker to its own channel of the amplifier, as shown on the chassis label. The INPUT CONFIGURATION switch must be set for STEREO or PARALLEL mode.
Bridge Mode: Bridge mode configures the channel pair to drive a single
OUTPUT TERMINAL SAFETY WARNING! Do not touch output terminals while amplifier power is on. Make all connections with amplifier turned off. Risk of hazard- ous energy!
PLX 1104 and PLX 1804 Output Connectors: Do not use less than 4 ohm impedance loads with PLX 1104 and PLX 1804 models.
PLX 1802, PLX 2502, PLX 3102, and PLX 3602 Output Connectors: Do not use less than 2 ohm impedance loads with these models.
8