CAUTION: Remove the power cord before removing the top cover. Dangerous voltages within the enclosure may be of sufficient magnitude to constitute a risk of
electric shock to humans.
Then lift the rear edge of the top cover about ¼ inch, or 6 mm, and slide the cover forward about 2 inches, or 5 cm. Lift the cover straight up to remove it from the chassis.
Re-installing the cover is the reverse of removal.
III. Installation
PRE-INSTALLATION PREPARATION: ANALOG SIGNAL LEVELS (RAVE 160, 161, AND 188 ONLY)
The RAVE models which handle analog audio inputs and/or outputs require a signal level set-up to achieve optimum performance. This configuration should be completed before rack-mounting the units. (The digital AES3 models, however, do not require any such adjustment.)
These adjustments are done internally by placing or arranging jumpers on the main circuit board. For access to these jumpers, you must first remove the top
cover of the RAVE unit as follows.
To remove cover, first detach the AC power cord, then remove screws from top, bottom, and sides. The arrows in this picture point to the 17 screw locations.
Required tools: medium Phillips screw- driver
Be sure to take proper protective measures, such as working on an anti-static surface and wearing a grounding wrist strap, before touching any circuitry inside.