Qualcast 16/18 manual Using your Mower, Starting and Stopping, After Mowing/Storage, Maintenance

4. Refit and tighten the oil filler plug.

Note: It is important to use the recommended oil to avoid damage to your engine.

Petrol

Note: Petrol deteriorates over time. Engine starting may be difficult if you use petrol kept for more than 30 days. Always run the fuel tank dry when storing over 30 days

1.Remove the petrol filler cap Fig 5C and add unleaded petrol to the tank, leaving approxi- mately 6mm of tank space for fuel expansion.

2.Replace the petrol filler cap.

3.Wipe up any spilt petrol from the engine before starting the mower.

Using your Mower

Grassbox Fitting

Grassbox

For non grass collection the mower can be used without the grassbox in position, with the deflector guard in the down position.

Fitting the grassbox

Lift the deflector guard and hold up Fig 6A Fit the grassbox Fig 6B.

Removing/Emptying

Lift the deflector guard and hold up - remove grassbox.

Height of Cut Adjustment

To adjust the front and rear wheels push the height- of-cut lever Fig 7A away from the notch Fig 7B.

For front wheels - Move lever to the rear to lower wheels, as shown Fig 7.

For rear wheels - Move lever forward to lower wheel as shown Fig 7.

Always ensure that ALL FOUR WHEELS are at the same height setting.

Before mowing

1.Check the engine oil level and fill the petrol tank.(See Preparation).

Note: Towards the end of the season, it is advisable to put only as much fuel in the tank as you need for each cut, since it should be completely used up before storing the mower. (See After Mowing/Storage).

2.Ensure that the upper handle is in position and secured by the wing nut Fig 2B.

3.Set the height of cut as required .(See Height of Cut Adjustment).

Starting and Stopping

Starting the Engine

1.For mowers with throttle controls: Move the throttle lever Fig 9A to

2.If the engine is cold, press the primer Fig 8A three times (five times in cold weather). If the engine is warm do not prime.

3.Hold the bale bar Fig 9B against the handle.

4.Pull the starter Fig 9C cord briskly one or more times until the engine starts. Allow the cord to return slowly after each pull.

Stopping the Engine

1.Release the bale bar Fig 9B. The engine will stop within 3 seconds.

To drive the Rear Roller (Self-propelled models only)

1.Start the mower (see above).

2.Squeeze the land drive bale bar Fig 9D towards the top handle. For mowers with throttle

control, adjust the speed as required by moving

the throttle control Fig 9A between and

4.To stop the drive, release the land drive bale bar Fig 9D.

After Mowing/Storage

Clean the exterior of the machine thoroughly using a soft brush and cloth. Do not use water, solvents or polishes. Remove all grass and debris, especially from the ventilation slots.

Tip the machine backwards or on its side (see Underdeck Access) Fig 10 and clean the blade area. If grass cuttings are compacted in the blade area, remove with a wooden or plastic implement.

For storage in excess of 30 days, run the engine until all petrol is used and the engine stops.

Store the machine in a dry place. Do not place other objects on top of the machine.

To aid storage loosen the handle wing nuts Fig 2B and fold the handles.

Ensure cable is not trapped when folding/unfolding top handles, DO NOT DROP THE HANDLES.

Maintenance

Stop the engine, and disconnect the spark plug wire.

Note: To ensure long and reliable service, carry out the following maintenance regularly.

Regularly check for obvious defects such as loose, dislodged or damaged blades, loose fixings, and worn or damaged components. Check that covers and guards are undamaged and correctly fitted.