FC420 Fibre Channel Bridge Quick Reference Guide
Step 2: Install FC420 Bridge(s)
1Turn off the library by pressing the power switch on each power supply at the back of the library.
2 Remove the power cable from the back of the library.
3If you are installing the first FC420 bridge in the library, use a flat blade screwdriver to loosen the two large thumbscrews securing the primary electronics module to the back of the library (see figure 1), then pull the primary electronics module from the chassis using the round handles.
4If you are installing a second or third FC420 bridge in an ATL M2500 library, remove the six screws that secure the secondary electronics module to the back of the library.
Save the six screws for reinstallation of the secondary electronics module.
ATL M1500 back panel | Primary electronics module |
Secondary electronics module |
|
| Thumbscrews |
ATL M2500 back panel |
|
Slots for |
|
additional |
|
FC420 | Slot for first |
bridges | |
| FC420 bridge |
Mounting screws
Handles
Figure 1 Removing the Primary and Secondary Electronics Modules
5Remove the two screws securing the expansion slot cover plate to the back of the electronics module and remove the cover plate.
Save the screws for use later in this installation. Save the cover plate for future use.
6Remove the screws securing the
7Carefully remove the new FC420 bridge from its antistatic packaging.
Caution: Hold the FC420 bridge by the edges, avoiding contact with the components and connectors.
2