Quasar PAG instruction manual Specification

U5047A PAG QUASAR INSTRUCTION MANUAL

1.10Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the supply cord or plug has been damaged, liquid has been spilled, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. In this event you should seek advice from your nearest PAG Dealer, or direct from PAG Ltd., London, by telephoning +44 (0)20 8543 3131.

SECTION 2

SPECIFICATION

2.1PAG Quasar range:

Model No. 9726

◗Two PAGlok connectors and two PP90 (2.1mm) connectors.

Model No. 9727

◗Two Snap-on compatible connectors and two PP90 (2.1mm) connectors.

Model No. 9752

◗Two PAGlok connectors and two PP90 (2.1mm) connectors.

◗Built-in Power Supply.

Model No. 9753

◗Two Snap-on compatible connectors and two PP90 (2.1mm) connectors.

◗Built-in Power Supply.

2.2Range of Batteries Charged:

◗Nickel-Cadmium batteries having nominal voltages of between

4.8V and 14.4V, and nominal capacities of between 1Ah and 10Ah.

◗Nickel-Metal Hydride batteries of reputable manufacture having nominal voltages of between 4.8V and 14.4V, and nominal capacities of between 1Ah and 10Ah.

◗PAG Lithium-Ion batteries.

U5047A PAG QUASAR INSTRUCTION MANUAL

◗Non-PAG batteries (other than Ni-Cd or Ni-MH) using appropriate PAG Intelligent Charge Adaptor.

2.3Battery Connections:

PAGlok connectors:

Patented professional connector compatible with all PAGlok batteries. Incorporates self-cleaning military-type beryllium-copper leaf contacts.

Snap-On compatible connectors:

Patented professional connector compatible with Li-Ion Time Batteries (Models 9366 and 9383), and most Anton-Bauer batteries (excluding Dionic batteries).

PP90 connectors:

Polarised connector suitable for 2.1mm coaxial DC power connectors. NOTE: centre pin negative.

2.4Main Charge Program:

◗Auto Mode - automatically selects the correct charge current.

◗Manual selection - 2A or 3A charge current.

◗Li-Ion voltage-charge program only available with PAG intelligent batteries or suitable PAG intelligent adaptor. PAG intelligent batteries automatically over-ride the Auto Mode or Manual selection, and control their own charge regime.

2.5Recovery Charge:

This special program conditions the battery for a period of one hour. The charger will then automatically enter the Main Charge program, which will run until the battery is fully charged. This program also recovers PAG Li-Ion batteries which have been over-discharged to the point where the internal safety protection circuit has tripped.

2.6Ancillary Charging Programs:

The following programs may be automatically entered after charging:

◗Balancing Charge.

3 4