Quatech SS-BLT-400 operation manual Terminator, Set Button

Follow the parameter setup procedures to configure the converter (see the following chapters).

Terminator

The purpose is for compensating signal attenuation in long distance connection at RS-485/RS-422 I/O. If the switch 1 & 2 are set in “ON” position, the signal compensation will be activated. To disable the function, just to push switch 1 & 2 to opposite position.

Set Button

Set Button

The purpose is for synchronizing between this Bluetooth To Serial Converter and “BT RS232 Config Tool” software. After finishing the parameter setup of “BT RS232 Config Tool” software, when you click the icon of “Connect” in “BT RS232 Config Tool” software and then use any point tip to push this button immediately on the left side of the device. You will see the icon of “Connect” turn into “Disconnect” and the meaning is successful to active the device.

8