Radio Shack 16-3499 quick start Before you get started, Selecting your antenna, What’s included

16-3499

Digital HDTV Receiver

Quick Start Guide

before you get started

You must find out which stations in your area are broadcasting in DTV. To find out which stations in your area are broadcasting in DTV and what kind of antenna system you will need, visit the following two websites:

www.titantv.com - Gives you local DTV channels, programming and station informaton.

www.antennaweb.org - Gives you station information, antenna selection suggestions and detailed antenna pointing information for both your DTV and analog TV signals.

Simply input your zip code and obtain most of the information you need. We advise you to enter exact address information since the website takes into account topographical data supplied by the US Geographical Survey for each specified address.

selecting your antenna

After noting all available DTV channels in your area from the websites provided, a suitable antenna must be selected. Determine which antenna best suits your needs.

•Can I use my existing analog TV Antenna?

If you receive good noise free, ghost free signals on your analog channels, especially UHF channels (most DTV signals are transmitted on UHF), you MAY be able to use your existing antenna system. In this case, to feed the TV signals to both the set-top box and your existing TV/VCR system, you will need to use a signal splitter (see Page 18). Passive signal splitters cause loss which can degrade the signal. If needed, contact your local RadioShack store for an Amplified 2-way splitter that will not degrade the signal.

•Can I use an indoor set-top antenna? In strong signal areas, without reflection problems, this may be satisfactory, but is not recommended. Your local RadioShack store sells antennas for cases where an indoor antenna is suitable.

•Do I need an antenna upgrade? If the above options are not satisfactory, then you need an antenna upgrade. Consult with your local RadioShack store.

•Choosing a new Antenna System:If all available DTV transmissions are from approximately the same direction, the installation should be simple and inexpensive. The websites can help with choice of antenna and pointing details. Ideally, antennas should be mounted high (e.g. on a chimney) and clear of obstructions. An attic installation may be satisfactory. If available DTV transmissions are from different directions, then either a motorized antenna (with a rotator) or an “area special” antenna system is required. You can purchase antenna rotators from your local RadioShack store or a professional antenna installer. Area special antennas are best handled by professional antenna installers.

See page 17 of your User’s Guide for more detailed information on setting up your antenna.

Thank you for purchasing your Accurian Digital HDTV receiver from RadioShack. Your receiver lets you receive high resolution picture quality and supports programs broadcasted in Dolby digital 5.1 surround sound.

what’s included

HDTV Digital Receiver	Component Cables
Audio Cables	Quick Start Guide

Owner’s Manual

NOTE	Actual product may vary from the
	images found in this document.

Please read this user’s guide before

installing, setting up and using your new product

www.radioshack.com

©2005. RadioShack Corporation.
All rights reserved. RadioShack and	16-3499
RadioShack.com are trademarks
	01A05
used by RadioShack Corporation.
	Printed in Korea

install your remote’s batteries

Remove your battery compartment.

Insert two AAA batteries, matching the polarity (+ and -) marked inside.

Replace your cover.

using your HDTV receiver

scan and store DTV channels into your HDTV receiver

Once you have installed your antenna and rotator (if needed), you should use the information you collected from the websites provided and point your antenna towards the direction where there are the largest number of DTV stations. If there are no previous channels stored in your HDTV receiver, the factory default

settings lets your receiver automatically scan for channels when you turn it on

Otherwise, use the AUTO SCAN MENU, followed by the RESCAN function (see page 27 of your User’s Guide) of the HDTV receiver to find and store all these stations into the receiver.

Press MENU on your receiver or remote.

	Press / on your remote or receiver to highlight the AUTO
	SCAN function.
 Press / on your remote or receiver to highlight CHANNEL
		Menu
	and press SEL.

 Press  or SEL to confirm your selection.

Note Do not use the RESCAN function, because it will erase the previously stored channels.

		Then, if necessary, rotate your antenna towards the direction where there are the second
		largest numbers of DTV stations. Select the UPDATE function in the AUTO SCAN menu to add
//SEL		new channels only and store the previously scanned channels. Continue the process until you
		store all channels you are capable of receiving. After these simple steps, you are now ready
		to enjoy crisp, clear, and FREE terrestrial/over-the-air DTV programming!