connect both components with the supplied
Do not mount the CD changer anywhere in your vehicle that is exposed to direct sunlight (such as the front or rear deck) or extreme heat (such as the engine compartment). Direct sunlight or extreme heat can damage CDs and the CD changer.
Mount the CD changer as level as possible. If you cannot mount the CD changer exactly level, make sure it will not tilt more than 15 degrees from the horizontal or vertical mounting position.
Make sure there is enough room for you to insert and remove the supplied CD magazine from the CD changer.
For the Audio Adapter
You can mount the supplied Audio Adapter (ground isolator and FM modulator) under your vehicle's dashboard.
Notes: The Audio Adapter's mounting area must be at least 5 inches (127
mm)wide and
When you choose a mounting area for the Audio Adapter, make sure it is close enough to your vehicle's ground, power, and sound system so you can connect them with the FM modulator and Ground Isolator's wires and plugs (see "Connecting the Audio Adapter" in Faxback Doc. # 57810).
For the CD Changer Controller
For ease of use, you can mount the supplied CD changer controller on the dashboard using the supplied
Note: When you choose a mounting area for the controller, make sure it is close enough to the Audio Adapter's mounting area so the controller's cord will reach the Audio adapter. The controller's cord is about 5 feet (152 cm) long.
Removing The Transport Screws
The transport screws help protect the CD changer from damage during shipment.
Before you mount the CD changer, use a small screwdriver to remove the
