OWNER’S MANUAL

6.Exit programming by pressing once. The display will return to the last-selected device menu screen.

7.To test the power macro, first make sure all home theater devices selected in step 4 are turned on. Aim the remote control at the devices and press MY SYSTEM once, followed by PWR once. The devices should turn off in this order: Satellite Receiver, DVD Player, Audio Receiver, and TV.

To turn on the devices on again in the same order as above, press PWR once.

PROGRAMMING THE COM MUTE KEY

If desired, a two-state rotating macro can be programmed onto the COM MUTE key, so a key press will drop volume (in the CBL, SAT, TV, VCR, or AUX mode) to a preset level during a commercial. When the program resumes, another key press will raise it back to the original level.

1.Press and hold P until the bottom IR segment flashes twice. The program keys will appear:

2.Press above MACRO once. The Macro programming screen will appear:

3.Press COM MUTE once. The last-selected device menu screen, including

, will be displayed.

4.Enter the first macro sequence by pressing TV once, then press VOL▼ four times (to lower the volume four steps).

5.To save the macro, press and hold P until the bottom IR segment flashes twice. The program keys will appear again.

6.To program the second macro, repeat steps 2 through 5, but substitute VOL ▲for VOL▼this time (to raise the level four steps).

7.Exit programming by pressing once. The display will return to the last-selected device menu screen.

continued on next page...

Using Macros 27