3” TFT LCD TV
16-3012
EXT. ANT. Jack - Lets you connect an external antenna for optimum reception in weak signal areas.
Tuning Ý /Þ - Press the control to adjust the TV to the desired channel.
Rod Antenna — provides adequate reception in most metropolitan areas
3” Flat LCD - makes the TV more compact and uses less power than a standard picture tube.
Optional Accessories
Power
BATTERY POWER
Your TV requires four AA batteries (not supplied). You may purchase alkaline batteries from your local RadioShack store.
1.Slide off the battery compartment cover.
2.Insert the batteries into the compartment
as indicated by the polarity symbols (+ and
3.Replace the cover.
Notes:
Stand - Use the stand to lean the TV against flat surfaces.
Volume - Turn the dial to adjust the volume level.
Bright - Turn dial to adjust the brightness level.
Ear Jack - Lets you enjoy private listening with an optional earphone.
6V Vehicle DC Adapter | Earphones |
Size B Adaptaplug | 6V AC to DC Adapter |
Alkaline Batteries
•The TV can operate for about 3 hours with alkaline batteries. When the sound level lowers or the picture becomes unstable, replace the batteries.
•The TV’s internal batteries automatically disconnect when you connect an adapter.
Using Your TV
AC POWER
You can power the TV using a regulated 6V AC adapter of at least 550 mA, and a size B Adaptaplug™ adapter (neither supplied). Both are available at your local RadioShack store.
Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s DC IN 6V jack. Then, plug the other end of the AC adapter cord into a standard AC outlet.
Note: The adapter might become warm after extended periods of use.
UHF/VHF/OFF
AUDIO/VIDEO
DC IN 6V Jack
1.Extend the rod antenna and slide UHF/VHF/OFF to VHF or UHF. The TV starts scanning and stops at the next active channel in the selected band.
2.Press 
TUNING 
to tune to a different channel. The tuning line on the screen aligns with the selected channel number below the screen.
3.To adjust the volume, rotate VOLUME located on the right side of the TV.
4.To adjust the picture to the desired brightness, rotate BRIGHT located on the right side of the TV. The brightness also changes with the screen’s angle.
BACKLIGHT |
|
|
| VOLUME |
|
|
| ||
In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red in color. |
|
|
| |
This is not a malfunction. Normal operation resumes after a few seconds. |
|
| BRIGHT | |
|
|
|
| |
USING AN EARPHONE |
|
| EAR Jack | |
For private listening, you can connect an optional earphone with a |
|
| ||
| ||||
|
|
| ||
USING VEHICLE BATTERY POWER
You can power the TV from a vehicle’s 12V power source (such as a
Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord,
aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s jack. Unplug the vehicle’s cigarette lighter and plug the large end of the DC adapter cord into the
Note: If the TV does not operate properly when you use DC power, be sure the cigarette- lighter socket is clean and that the adapter’s plug is properly connected to the socket.
This automatically mutes the |
Cautions:
•Set VOLUME to the lowest setting before you begin listening. Then adjust the volume to a comfortable level.
•Do not use an earphone when operating a vehicle or riding a bicycle. This can cause a traffic hazard and can be illegal in some areas.
USING THE TV AS A MONITOR
You can play back the signal from an audio/video component connected to your TV’s AUDIO/VIDEO jack. You will need a
Note: Connecting an audio/video component disables the TV’s antenna.
