Manuals / Aqua Products / Lawn and Garden / Portable Generator

Aqua Products CC-350 M o u n t t h e C o n t r o l B o, Flow sensor connectors 2. Cell connectors

Models: CC-550 CC-350

1 24

Download 24 pages 35.38 Kb

Page 6

M o u n t t h e C o n t r o l B o x

M o u n t t h e C o n t r o l B o x

1.The Control Box must be mounted vertically on a flat surface and a minimum of 5 ft (1.5m) horizontal distance (or more, if local codes require) from the pool/spa.

2.Locate a position for your Control Box within 10 ft (3½ meters) of where the Cell will be installed and within 2 ft of the power supply to ensure enough wire is available.

3.Because the box acts as a heat sink dispersing heat from inside the box, do not block the four sides of the Control Box. Do Not mount the system inside a panel or tight enclosed area.

3

1.Flow sensor connectors

2.Cell connectors

3.	Bonding	4
4.	Power Cord

4. Secure the hanging rack on the wall

using the enclosed screws and anchors. 1/4” (8mm) drill bit should be used for the anchor holes.

5. Hang the Control Box on the mounted hanging rack.

1

2

6.Hardwire the power cable to the time clock as indicated in the instructions below. *Check the label on the side of the Control Box for the proper voltage specification on your system (i.e. 120v or 240v).

7.Do not extend the cable leading to the cell. This decreases the system’s efficiency and will void warranty coverage. Please contact the manufacturer for installations demanding a longer cell cable.

6

Image 6

Aqua Products CC-350 M o u n t t h e C o n t r o l B o, Flow sensor connectors 2. Cell connectors, Bonding, Power Cord

Contents

OWNER’S MANUAL WARRANTY COVERAGEPLEASE NOTE THIS MANUAL MUST BE GIVEN TO THE HOMEOWNER TO ENSURETROUBLESHOOTING T A B L E O F C O N T E N T SINSTALLATION WARRANTYW E L C O M E WARNING SAFETY FIRSTSafety Measures Flow switchPower / Timer Control BoxFlow direction I n s t a l l t h e C e l lI n s t a l l t h e F l o w S e n s o r Flow directionM o u n t t h e C o n t r o l B o 1. Flow sensor connectors 2. Cell connectorsPower Cord BondingW i r i n g t h e C o n t r o l B o x t o S t a n d a r d T i m e r 240Volt Circulation Pump With 240 Volt Chlorine Generator 120Volt Circulation Pump With 120 Volt Chlorine GeneratorW i r i n g t h e C e l l 220Volt Circulation Pump With 220 Volt Chlorine Generator120Volt Circulation Pump With 240 Volt Chlorine Generator W i r i n g t h e F l o w S e n s o rADDING THE SALT S T A R T U PBEFORE ADDING THE SALT UNACCEPTABLE SALTS Do Not UseSalt level before addition in PPM Water volume in thousands of GalloonsS A L I N I T Y D E M A N D T A B L E i n l b s How much sat to add - in poundsFiltration O P E R A T I N G I N S T R U C T I O N S BACKGROUNDBASIC OPERATION Sanitation/OxidationC O N T R O L S Page Cell Maintenance Diluted muriatic acid solution = 10 parts water to 1 part acidCleaning With Optional Cleaning Cap Cell CleaningCleaning Without Optional Cleaning Cap OptionalU N D E R S T A N D I N G T H E C H E M I S T R Y SaltPage S A T U R A T I O N I N D E 12.2T R O U B L E S H O O T I N G T R O U B L E S H O O T I N G Check the Cell to ensure the blades are1. Model and Serial # 2. Date of installation 3. Installing company or dealer4. Current salt level and chemical levels PROOF OF PURCHASE WARRANTYEXCEPTIONS & LIABILITY LIMITATIONS Ten 10 Year Limited WarrantyAQUA COMFORT TECHNOLOGIES, LLC ATTN WARRANTY DEPT. AC P.O. BOX RETURN ADDRESSSYKESVILLE, MD