Radio Shack 21-1177 manual Mounting the Clip Hanger, Connecting the Microphone, Using Microphone

21-1177.fm Page 2 Thursday, August 5, 1999 8:44 AM

MOUNTING THE CLIP HANGER

You can hang the microphone on your CB’s existing mounting bracket, or use the supplied clip hanger and screws.

To mount the clip hanger, use it as a tem- plate and drill two holes at the desired lo- cations on the vehicle’s dashboard. Then use the supplied screws to mount the clip hanger on the dashboard.

Caution: Be sure not to drill into objects behind the dashboard.

CONNECTING THE MICROPHONE

Plug your microphone’s 5-pin connector into your transmitting device’s plug.

USING THE

MICROPHONE

Push the switch on the microphone’s side to send a transmission. Release the switch to receive.

USING THE AMP

To use the microphone’s internal pream- plifier, set AMP. ON/OFF to ON. Adjust VOL. to vary the output level of the ampli- fier. To turn off the amplifier, set the switch to OFF.

Note: The VOL. setting only affects your transmitting volume and only works with AMP. ON/OFF set to ON.

2