2.Plug one end of the supplied long telephone cord into the jack on the bottom of the base.
3.Plug the cord’s other end into a modular phone jack.
4.Line up the keyhole slots with the screws in the wall, then slide the phone down until it is secure.
5.Before you hang up the phone’s handset, slide up the handset holder to remove it, turn it over so its tabbed edge faces up, then slide it back down into its slot.
Note: The USOC number of the jack to be installed is RJ11C (RJ11W for a wall plate jack).
USING THE PHONE
Set the ringer volume by sliding RINGER to H (high) for a louder ring in a noisy room, or to L (low) for a softer ring in a quiet room.
T/P
VOLUME
LO/MED/HI
RINGER
H/L
Set T/P to T (tone) or P (pulse) to match the type of service you have.
Set VOLUME to LO (normal), MED (medi- um), or HI (high) for a comfortable listen- ing level.
Press REDIAL to dial the last number di- aled.
Note: If you will be redialing a number preceded by an access code (9, for ex- ample), dial the access code, press PAUSE, then dial the number.
Press FLASH to perform the switchhook operation for special services, such as Call Waiting. If you do not have a special phone service, pressing FLASH might disconnect the current call.
Note: The redial memory does not store a FLASH entry or any digits entered be- fore you press FLASH.
3
