Radio Shack 49-426 owner manual +056#..+06*$#664, 100%6+06*/16+10&6%61461, 10#&5-146#$

2QTVCDNG"/QVKQP"&GVGEVQT

YKVJ"#NCTO

49-426

OWNER’S MANUAL — Please read before using this equipment.

#"+/2146#06"#

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

Rý— Signifies a Warning

.— Signifies a Caution

#— Signifies Important text

Your RadioShack Portable Motion Detector with Alarm is a pocket-sized, dual- pyroelectric infrared sensor alarm that provides reliable protection. It is perfect for home, business, and travel security.

You can use the motion detector to alert you to possible intruders or sound a pleasant

chime when someone enters the area. You can also connect one or two external hard- wired magnetic sensors or passive infrared (PIR) detectors to the motion sensor to serve as a small security alarm system. This motion detector is for indoor use only.

+056#..+0)"6*'"$#66'4;

ýR"9#40+0)ýR"

Dispose of old batteries promptly and properly. Do not burn or bury them.

."%#76+10".

•Use only a fresh battery of the required size and recommended type.

•If you do not plan to use the motion detector for a month or more, remove the battery. Batteries can leak chemicals that can destroy electronic parts.

Your motion detector requires one 9V battery (not supplied) for power. For the best performance and longest life, we recommend a RadioShack alkaline battery. R .

1.Lift the mounting bracket to access the battery compartment.

2.Slide the battery compartment cover in the direction of the arrow to remove it.

3.Remove the mounting screws and anchors stored inside the battery

compartment. Keep the screws and anchors in case you want to mount the motion detector on a wall.

4.Snap the battery onto the battery terminals inside the battery compartment.

5.Replace the cover.

When the alarm sound weakens or the motion detector stops operating properly, replace the battery. .

%100'%6+0)"6*'"/16+10"&'6'%614"61" 5'05145

±"016'"±"

•	To prevent the motion detector’s chime
	from sounding after you install the battery,
	CHIME/OFF/ALARM is preset to OFF.
•	If the alarm sound weakens or the red
	indicator flashes, replace the battery. If the

You can connect the motion detector to one or two external hard-wired magnetic sensors or PIR detectors (not supplied).

1.Loosen the screw terminal’s screws inside the battery compartment.

2.Insert the sensor’s or PIR detector’s wires into the wire hole under the terminals, then tighten the screws.

To install detector(s) with the mini alarm:

1.Use needle nose pliers or a sharp instrument to punch through the knock- out hole on the bottom of the battery compartment.

2.Use a flat-blade screwdriver to secure the detector wires to the nodes, then guide the wire out.

3.Place the wires so they are not stepped on or in a place where they interfere with normal activities.

battery is dead, the red indicator does not

light.

+056#..+0)"6*'"/16+10"&'6'%614

• Do not install the motion detector in an

area where sun shines directly on it or

where it might get wet.

• Do not install the motion detector near a

heat source such as a radiator, stove top,

or light.

• Avoid locations where extreme

temperature changes might occur.

• Avoid places with high humidity (such as a

bathroom).

Before you install the motion detector, choose a location where the entry point (door or window) is within the motion detector's detection angle (100 degrees). The motion detector detects motion best when the object moves across the detection angle, rather than directly toward or away from the motion detector.

10"#"&'5-"14"6#$.'

1.With the flat side of the bracket pointing toward the top of the sensor, slide the bracket’s grooved slots onto the mounting tabs on both sides of the battery compartment until it snaps into place.

2.Rotate the bracket to the desired angle, then place the sensor on a desk or table.

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks

used by RadioShack Corporation.