
changing your unit code
You only need to change the unit code of the first rocker key. The other two rocker keys default to the next highest number after you set the first rocker key. For example, if you set the first rocker key to 4, the other two rocker keys default to 5 and 6, respectively.
To set the unit code on the first rocker key, hold down OFF for about three seconds and release it. The LED blinks to indicate the current setting, one time for unit code 1, two times for unit code 2, and three times for unit code 3.
changing your house code
The wall switch is preset to house code A. The first three rocker keys on your wall switch are preset to control modules that are set to unit codes 1, 2 and 3, respectively. The last one brightens or dims lights connected to lamp and wall switch modules.
Hold down the first ON rocker key for about |
three seconds and release it. The LED blinks |
to indicate the current setting - once for |
house code A, twice for house code B, and |
three times for house code C. |
THE FCC WANTS YOU TO KNOW
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• | Reorient or relocate the receiving antenna. |
Press OFF the appropriate number of times to correspond with the desired setting. For example, press four for unit code 4, five times for unit code 5, and so on.
Hold down OFF for three seconds on your last press. The LED blinks the new unit code. If it does not, repeat the programming sequence.
Use the OFF rocker key to set your unit code.
Press ON the appropriate number of times to correspond with the
desired setting. For ON rocker key
example, press once for setting A, twice for setting B, and so on.
Hold down ON for three seconds on your last press. The LED blinks the new house code setting. If it does not, repeat the programming sequence.
• Increase the separation between the equipment and |
receiver. |
• Connect the equipment into an outlet on a circuit |
different from that to which the receiver is connected. |
• Consult your local RadioShack store or an |
experienced radio/TV technician for help. |
• If you cannot eliminate the interference, the FCC |
requires that you stop using your wall switch. |
• Changes or modifications not expressly approved |
by RadioShack may cause interference and void the |
user’s authority to operate the equipment. |
using your wall switch
Press ON or OFF to control the lamps and appliances that correspond to your module’s unit codes.
To brighten or dim your lights, press the rocker key that corresponds to the module’s unit code, and then press the last rocker key (BRIGHT/DIM).
Caution: Do not use your wall switch with an unattended coffee pot or heater. This may cause a serious fire hazard.
ON/OFF
BRIGHT/DIM
limited 90-day warranty
This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack
RadioShack Customer Relations
©2004. RadioShack Corporation. | |
All rights reserved. RadioShack and | 06A04 |
RadioShack.com are trademarks | Printed in China |
used by RadioShack Corporation. |
|
200 Taylor Street, 6th Floor, Fort Worth, TX 76102 04/04