5KPING"$GNN"9KTGNGUU"&QQT"%JKOG
| OWNER’S MANUAL — Please read before using this equipment. |
|
|
#"+/2146#06"#
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.
Rý— Warning | ° — Hint |
. — Caution | ± — Note |
# — Important |
|
Receiver | Transmitter |
Indicator — Lights when
BELL is pressed.
Slide ON/OFF to ON
so that when BELL | BELL — Press BELL | |
to hear the door | ||
is pressed on the | ||
chime. | ||
transmitter, a door | ||
| ||
chime sounds. |
|
."%#76+10".
•Use only fresh batteries of the required size and type. Always remove old or weak batteries. They can leak chemicals that destroy electronic circuits
•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
Thank you for purchasing the RadioShack Single Bell Wireless Door Chime. It works as a doorbell, remote pager, or alert. You can add an optional external sensor to have a chime that alerts you when someone walks into a room. The door chime’s
/1706+0)"6*'" 4'%'+8'4
10"#"(.#6"574(#%'
Pull out the wire stand on the back of the receiver and set it on a table or other flat surface.
10"#"9#..
1.Drill one
2.Drive the supplied M3.5 screw into the hole until the screw's head extends about 1/8 inch from the wall.
3.Align the keyhole slot on the bottom of the receiver with the screw in the wall, then slide it down to secure it.
/1706+0)"6*'" 64#05/+66'4"
1.Remove the transmitter from the holder.
2.Use the holder as a template to mark two screw holes on the wall.
3.Remove the holder from the mounting surface and drill two 3/16 inch diameter holes. Insert one of the supplied anchors into each hole.
4.Drive a screw through the holder into each hole.
5.The transmitter can be slid in and out of the holder. To lock the transmitter, fix it with a size M2.6 screw at the bottom of the holder.
+056#..+0)"
$#66'4+'5"#0&" 5'.'%6+0)"%*#00'.5
The door chime requires three AAA batteries in the transmitter and three C batteries in the receiver. For best performance and longest life, we recommend RadioShack alkaline batteries. .
+0"6*'"64#05/+66'4
1.Slide the transmitter's battery compartment door in the direction of the arrow to remove it.
2.Use a small
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.