Radio Shack 63-1415 manual

		Vibrating Alarm Clock
www.radioshack.com™
OWNER’S MANUAL —		63-1415
Please read before using this equipment.
		About 5 seconds after you install the
Ô NOTE Ô
		batteries, the clock vibrates and beeps three
• The default alarm time is set to 12:01. Press		times. 12:00 00 and M appear. Ô
SET/ALM to turn off the alarm before you set		When the clock stops operating properly or
the time. M disappears.
• Each time you press any button, the clock		the display dims, replace the batteries.
beeps.		USING THE COVER
• While setting the time, if you do not press a
key for about 30 seconds, the clock beeps		Your clock’s cover protects the display and
and returns to the current time display.
• The clock uses the 12-hour format. PM	MODE	also serves as a stand so you can place the
		clock on a table or other flat surface. To use
appears for a PM hour.	SET/
		the cover as a stand, lift and open the cover
• While setting the alarm time, if you do not
	ALM	all the way.
press a key for about 30 seconds, the clock	UP/
beeps and returns to the current time display.
	SNZ START/	SETTING THE TIME
• To turn on or off the alarm, press SET/ALM.
	LIGHT
Mappears when the alarm is turned on, and		1. Press MODE. Oappears and the hour
disappears when the alarm is turned off.	Thank you for purchasing a RadioShack
	Vibrating Alarm Clock. Your clock combines	digits flash. Ô
	a simple design with advanced technology.	2. Repeatedly press (or hold down) UP/SNZ
	You can set the clock to beep or vibrate
		to set the hour.
	(without disturbing others around you) at the
	preset time. Its lightweight design lets you	3. Press SET/ALM to store the hour. The
	carry it anywhere.
		minute digits flash.
	Clock Alarm  beeps or vibrates at a time
oWARNING o		to set the minute. The second digits
	you set.
		4. Repeatedly press (or hold down) UP/SNZ
Dispose of old batteries promptly and properly.		automatically return to 00 when you
Do not burn or bury them.	Snooze Control  temporarily silences the
		adjust each minute.
	alarm.
	Backlight  lights the display for about 3	5. Repeatedly press MODE until the current
		time appears. Ô
	seconds so you can see the time in the dark.
		SETTING THE
	Timer  lets you count down time from a
	preset time less than 24 hours.	ALARM TIME
CAUTION	Clock Cover  protects the display and
		You can set the clock to sound an alarm to
• Use only fresh batteries of the required size	serves as a stand.
		remind you of a daily event (such as a
and recommended type.
types of batteries (standard, alkaline, or	INSTALLING	meeting). Ô
• Do not mix old and new batteries, different		1. Press MODE twice. Land 12:01 or the
rechargeable), or rechargeable batteries of	BATTERIES
		last alarm time appear. The hour digits
different capacities.	Your clock requires two AAA batteries (not	flash.
• If you do not plan to use the clock for a month
	supplied) for power. For the best
or more, remove the batteries. Batteries can		2. Repeatedly press (or hold down) UP/SNZ
	performance and longest battery life, we
leak chemicals that can destroy electronic		to set the alarm hour.
parts.	recommend RadioShack alkaline batteries.
	o	3. Press SET/ALM. The minute digits flash.
	1. Slide the clock’s battery compartment	4. Repeatedly press (or hold down) UP/SNZ
	cover on the back of the clock in the
		to set the alarm minute.
	direction of the arrow and remove it.
	2. Place two AAA batteries in the	5. Repeatedly press MODE until the current
		time appears.
	compartment as indicated by the polarity
	symbols (+ and –) marked inside.	6. To check the alarm time, repeatedly
	3. Replace the cover.	press MODE until L and the set alarm
		time appear.

! IMPORTANT !

If an icon appears at the end of a paragraph, go to the box on that
page with the corresponding icon for pertinent information.
o — Warning Ô — Note	— Caution

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks

used by RadioShack Corporation.