Radio Shack ET-1119 owner manual Storing a Name and Number in Memory, Store Name appears

43-1119.fm Page 15 Thursday, September 16, 1999 1:58 PM

Each stored number can be up to 20 digits, and each name can be up to 14 characters.

Storing a Name and Number in Memory

Notes:

•An error tone sounds and the phone exits the storing process if you wait more than 20 seconds between each key press.

•If you receive a call during memory entry, the phone exits the storing process.

Follow these steps to store a number in memory.

1.Lift the handset.

2.Hold down MEM until Memory Store and a list of memory loca- tion numbers appears.

3.Choose a memory location (1-0) by pressing a number or by repeatedly

pressing or .

4.To store a name, press SELECT.

Store Name appears.

If you do not want to enter a name, skip to Step 6. <Memory n> will be stored as the name (n is the location number you selected).

5.To enter a name, use ▲ or ▼ to select the characters and REDIAL or FLASH to move the cursor.

Repeatedly press ▼ to view the characters in alphabetical order. The display shows uppercase let- ters first, then lowercase letters, numbers, and special characters. Press ▲ to view the characters in reverse order. You can hold down ▼ or ▲ to scroll rapidly through the characters.

If you make a mistake, move the cursor over the error, then enter the correct character, or press DELETE to delete a character. To delete all the characters, hold down DELETE for at least 1 second.

6.Press SELECT. Store Number appears.

7.Enter the phone number and any tone or pause entries (see “Using Tone Services on a Pulse Line” on Page 14 and “Entering a Pause” on Page 16).

8.Press SELECT. The phone beeps and Memory n Stored appears. After 2 seconds, Memory Store appears, and you can repeat Steps 3–8 to store more numbers.

9.When you finish, press MEM to exit

Memory Store.

15