MOUNTING THE PHONE
Desk Mounting
Modular Telephone Jack
USING THE PHONE
Set RINGER to HI in a noisy room. Set it to
LOW in a quiet room.
Switch to TONE or PULSE to match the type of service you have. If you have pulse (rotary) service, you can switch to TONE during a call to use tone services.
(Back of Telephone)
Wall Mounting
(With or Without Wall Plate)
Wall Plate
Press HOLD to hang up the handset without disconnecting the call. To release a call from hold, lift the handset.
Press FLASH in place of the switchook for special services such as call waiting.
Short Line Cord
(Not Supplied)
Line Cord | To Jack |
Handset Holder (Wall Mounting)
1.Pull out.
2.Rotate 180°.
Press REDIAL to dial the last number dialed (up to 31 tone or 32 pulse digits).
Press to disconnect a call.
Note: The phone company can charge you for the instal- lation of the necessary jacks. The USOC number of the jacks to be installed is RJ11C (RJ11W for a wall jack).
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol is intended to alert you that parts inside the telephone present a risk of electric shock.
This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.
Plug the handset cord into the jacks
on the handset and base.
Indicator — Li ghts when a call is on hold. Turns off when you lift the handset.
Press for special services.
ã ÐÐ
1994 Tandy Corporation.
All Rights Reserved.
Radio Shack is a registered trademark used by Tandy Corporation.
