43-686.fm Page 7 Friday, September 10, 1999 3:13 PM

Note: If you connect the phone to a two-line phone jack with a two-line cord, do not connect a cord to the TEL LINE 2 jack or the phone will not operate properly. Instead, you can connect another phone device, such as a fax machine or modem.

To connect the phone to two one- line phone jacks, plug one end of the supplied long two-line modular cord into TEL LINE 1/2 and plug another cord (not supplied) into the TEL LINE 2 jack.

To connect the phone to a single one-line phone jack, plug one end of the supplied long modular cord into the TEL LINE 1/2 or TEL LINE 2 jack.

Note: If you connect the phone to a single one-line phone jack, do not press the unused line button or you might hear feedback.

2.Plug the supplied AC adapter’s bar- rel plug into the DC IN 9V jack on the back of the base.

3.Route the adapter’s cord through the strain relief slot on the bottom of the bracket.

4.Plug the adapter into a standard AC outlet.

5.Connect the phone cord(s) to the modular phone line jack(s).

6.Raise the base’s antenna to a verti- cal position.

On a Wall or Wall Plate

Note: To mount the base directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the bracket. Drill two holes 315/16 inches apart. Then thread a screw into each hole, letting the heads extend about 5/16 inch from the wall.

7

Page 7
Image 7
Radio Shack ET-686 owner manual On a Wall or Wall Plate