VHF WIRELESS GUITAR SYSTEM
OPERATION MANUAL
Thank you for buying the PGW170 VHF Wireless Guitar System. Please read through these operation instructions so you will know how to operate your model properly. After you read it, put it away in a safe place for future reference.
Precautions
Receiver
Body pack transmitter
Installation
Specifications
Avoid exposure of the system to rain or moisture.
No
Handle the wireless system carefully, dropping or other shocks may cause failure.
Avoid using the system where it may be subjected to heat, such as direct sunlight, near radiators or other heat sources.
Should any liquid be spilt on the system, stop using it immediately. It may be possible to dry the system, but you should have it checked by a qualified technician before using it again.
Take care with the main power adapter and lead. If damaged in any way, do not use the system and refer to a qualified technician for repair.
Only use the system with the supplied components. Do not attempt to use with any other main power supply adapter .
If the wireless system is not going to be used for a while, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove the leakage with a damp cloth. Take care not to get battery electrolyte in contact with your skin, however if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately.
Only replace the battery with the same or an equivalent type.
Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation.
Do not use any solvents to clean any part of the wireless system .
Switch on the guitar wireless system receiver unit by pressing the POWER switch and the POWER light will illuminate to show the receiver unit is working. Raise the antenna to the maximum height. Switch ON the guitar wireless transmitter, checking that the red LED comes on for a second and then goes off. When the transmitter is ON, the SIGNAL light will illuminate on the receiver unit.
The guitar wireless system is now ready for use. Adjust the volume and tone level of
your amplifier system as well as on the receiver & the bodypack as required. When
the guitar wireless system is not being used, turn OFF the guitar wireless system.
Note that switching the guitar wireless system on and off can cause interference that will be heard if the guitar wireless system volume level of the amplifier system is still set high.
1
2
