Radio Shack PRO-2018 owner manual 7UKPI6WPG, Using Tune

1.To store the displayed frequency in the lowest available channel in the assigned channel-storage banks, press ENT when you find a frequency. The channel number flashes.

2.Press ENT again to store the frequency. The channel and frequency flash twice. If you want to cancel the operation, press TUNE/CLEAR instead of ENT.

To scan the channel-storage banks, press the one touch bank key, then SCAN/MAN while <?h;%FEb_9;, 7?h, or >7C appears. ±

If there is no empty channel at an available bank, XýNý#<KBB (where N is the bank number) appears after you press ENT. To store more frequencies, you must clear some channels.

See “Clearing a Stored Channel” on Page 19. To continue searching after XýNý#<KBB appears, press TUNE/CLEAR.

7UKPI"6WPG

You can set the scanner to search through all receivable frequencies from a specified frequency. You can use the scanner's delay feature while using tune. ±

1.Repeatedly press SCAN/MAN until C7D appears.

2.Enter the desired channel number you want to use as a starting point for the tune. Then press SCAN/MAN again.

3.Press TUNE/CLEAR to start tune. #j# appears.

4.Hold down H or G for about 1 second to tune up or

down. H or G appear and the scanner searches the frequencies. ±

5.When the scanner finds an active frequency, it stops searching and displays the frequency's number.

6.To search for another active frequency, hold down H or G for about 1 second.

Once you find interesting frequencies during the search, you can store them in the scanner’s channel-storage banks. Frequencies found during tune search are automatically assigned to channel-storage banks 9 and 10.

1.To store the displayed frequency in the lowest available channel in the assigned banks, press ENT. The channel number flashes.

±"016'"±"

Searching the One Touch Banks

If you entered a frequency that is already stored in another channel, #ZKFB# (duplicate) and the lowest- numbered channel containing the duplicate frequency flash for about 3 seconds. If you want to store the frequency anyway, press ENT again. You can then delete the frequency later. See “Clearing a Stored Channel” on Page 19.

Using Tune

•To reverse the tuning direction at any time, hold down H or G

for about 1 second.

•To tune up or down the selected band in small increments (5 or

12.5 kHz steps), repeatedly press H or G.

•To pause tuning, press H or G. To resume tuning, hold down H or G.

•To quickly move up or down

through the frequencies, hold down H or G. The scanner

tunes through the frequencies until you release H or G.

•If there is no empty channel, Xý/ý'&ý#<KBB appears after you press ENT. To store more frequencies, you must clear some channels. See “Clearing a

Stored Channel” on Page 19. To continue tuning after Xý/ý'&ý# <KBB appears, press TUNE/

CLEAR.

Searching the One Touch Banks

17