Radio Shack PRO-2018 owner manual 5ECPPKPIVJG5VQTGF%JCPPGNU, 6WTPKPI%JCPPGN/5VQTCIG$CPMU1HHCPF1P

Searching the One Touch Banks

±"016'"±"

Scanning the Stored

Channels

•To reverse the scanning direction, press H or G.

•To set the scanner to remain on the current channel for 2 seconds after the transmission ends, see “Delay” on Page 20.

•To set the scanner to remain on the current channel, even after the transmission stops, press

SCAN/MAN at any time during the transmission. C7D appears and I97Dýdisappears (see “Monitoring a Stored Channel”

on Page 18).

•To lock out channels so the scanner does not stop for a transmission on those channels, see “Locking Out Channels or Frequencies” on Page 21.

Turning Channel-Storage Banks Off and On

•The scanner does not scan any of the channels within the banks you have turned off.

•You cannot turn off all banks. There must be at least one active bank.

•You can manually select any channel in a bank, even if the bank is turned off.

•When you turn on a bank during scanning, the scanner moves to the selected bank and scans it.

2.Press ENT again to store the frequency. The channel and frequency flash twice. If you want to cancel the operation, press TUNE/CLEAR instead of ENT. After

storing the frequency, the scanner continues to search for frequencies. ±

5ECPPKPI"VJG"5VQTGF"%JCPPGNU

To set the scanner to continuously scan through all channels with stored frequencies, repeatedly press SCAN until I97D and H appear. The scanner rapidly scans until it finds an active frequency.

If the scanner finds an active frequency, it stops and displays that channel and frequency number, then it automatically begins scanning again when the conversation on that frequency ends unless delay is set for the channel (see “Delay” on Page 20). ±

6WTPKPI"%JCPPGN/5VQTCIG"$CPMU"1HH"CPF"1P

Channel-storage banks (1-10) are on when they have a bar underneath them and off when no bar appears underneath them. To turn off a channel-storage bank, press the bank's number key during scanning. The bar under the bank's number disappears.

To turn on a channel-storage bank (1-10) during scanning, press the bank's number key. A bar appears under the bank's number. ±

If no transmission is found, the scanner continues to scan through all selected banks.

/QPKVQTKPI"C"5VQTGF"%JCPPGN

You can continuously monitor a specific channel without scanning. This is useful if you hear an emergency transmission on a channel and do not want to miss any details – even though there might be periods of silence – or if you simply want to monitor that channel.

Follow these steps to manually select a channel.

1.Repeatedly press SCAN/MAN until C7D appears.

2.Enter the channel number (1-200).

3.Press SCAN/MAN again.

18