Changes to “Clearing All Lock Out Frequencies in a Search Bank” on Page 50 of your Owner’s Manual
•Step 1 should read “Press FUNC then press SEARCH. “
•Step 2 should read “Select the search bank from which you want to clear all
•Please add “Press SEARCH to continue searching” as Step 4.
Changes to “Changing the Frequency Step” on Page 54 of your Owner’s Manual
•Step 3 should read “Turn SQUELCH fully counterclockwise until the indicator points to MIN” instead of “Press FUNC then STEP.” **PAUSED** appears on Line 3.
•Step 5 should read “Turn SQUELCH clockwise and leave it set to a point just after the hissing noise” instead of “Press FUNC then STEP to return to scanning.”
Digital Weather Alert Feature
This feature supercedes “Weather Alert Feature” on Page 47 of your Owner’s Manual.
The weather service precedes each weather alert with a digitally- encoded SAME signal, then a 1050 Hz tone. You can set the scan- ner so, if you are monitoring a weather channel with a digitally- encoded SAME signal when an alert is broadcast, the scanner will decode and display the SAME message, showing the type of alert being broadcast (or Unknown Message if it does not recognize the event code).
To set the scanner to decode and display SAME messages, press FUNC then WX while you listen to the weather channel. DIG WX STBY and Cancel: F+WX appear.
To turn off SAME standby mode, press FUNC then WX. DIG WX STBY disappears.
Notes:
•The scanner does not display the actual location referenced by SAME messages. It uses only the message portion of the SAME signal.
•Your scanner can also receive weather alert tones (see “Prior- ity” on Page 51).
2