Radio Shack PRO-LS200 manual Care

Note: For the best overall performance, connect your speaker so it is in phase positive to positive (+ to +) and negative to negative (– to –).

1.With the speaker in its approximate location, measure the distance to the amplifier and route the wire from the speaker to the amplifier.

2.Separate the wire conductors for a length of about 2 inches, then remove about 1/2 inch of insulation from the wire’s ends using a wire stripper.

1/2''

3.Press the speaker’s black negative (–) terminal tab and insert one of the bare wire ends into the opening. Then release the tab.

4.Press the speaker’s red positive (+) terminal tab and insert the other bare wire end into the opening. Then release the tab.

5.Connect the other end of the wire from the speaker’s black terminal to the amplifier’s negative center (–) terminal, and the wire from the speaker’s red terminal to

theamplifier’s positive (+) center terminal.

Black Terminal

(–)

Red Terminal

(+)

Care

Keep the PRO-LS200 dry; if it gets wet, wipe it dry immediately. Use and store the speaker only in normal temperature environments. Handle the PRO-LS200 carefully; do not drop it. Keep the PRO- LS200 away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new. Modifying or tampering with the PRO-LS200’s internal components can cause a malfunction and might invalidate its warranty

Caution: You might permanently damage your speakers by cleaning them with a vacuum cleaner. Use a feather duster or a soft loose cloth instead.

This speaker has been manufactured to the specifications of RadioShack and is covered by a limited warranty from RadioShack. If your receiver is not operating as it should, take it to your local RadioShack store or call 1-800-THE- SHACK for assistance.

3