Radio Shack TAD-1006 owner manual Problem Solving, Problem Cause Remedy

43-768.fm Page 30 Friday, August 13, 1999 2:49 PM

PROBLEM SOLVING

We do not expect you to have any problems with your TAD-1006, but if you do, try these suggestions. If the TAD-1006 still does not operate as you think it should, take it to your local Radio Shack store for assistance.

Problem	Cause	Remedy
The TAD records a dial	The caller hung up without	Press NEXT (or 9
tone, siren, beeping, or	leaving a message or without	remotely) to play the
an operator’s voice	using the maximum time, and	next message.
instead of the caller’s	your local telephone com-
message.	pany does not send out CPC
	signals.
	The phone line is not properly	Check all phone line
	connected.	connections.
The TAD does not	The TAD is not plugged into	Make sure the AC
	power.	adapter is properly
answer calls.
		connected to the
		TAD and to power.
	The TAD is not set to answer	Press ON/OFF so the
	calls.	ANSWER indicator
		turns on.
	You were too close to the TAD	Re-record the
	or you spoke too loudly when	announcement,
	recording the announcement.	speaking in a normal
The outgoing		tone of voice about
announcement		12 inches from the
is distorted.		TAD.
	There was too much back-	Re-record the
	ground noise in the room	announcement.
	when you recorded the
	announcement.
The TAD does not play	The outgoing announcement	Record a new outgo-
the outgoing	is less than 2 seconds long.	ing announcement
announcement you		that is at least 2 sec-
recorded.		onds, but no more
		than 1 minute long.
30