•a 13.8V DC power supply that supplies at least 1.5 amps (available from RadioShack)
Caution: Most 13.8V DC power sup- plies plug into a standard AC outlet to produce DC power. Before connecting your CB to a 13.8V DC power supply, read and follow the instructions included with the power supply.
•base station antenna (available from RadioShack)
•coaxial antenna cable and connector (available from RadioShack)
Warning: Use extreme caution when you in- stall or remove a base station CB antenna. If the antenna starts to fall, let it go! It could contact overhead power lines. If the antenna touches the power line, contact with the an- tenna, mast, cable or guy wires can cause electrocution and death. Call the power com- pany to remove the antenna. Do not attempt to remove it yourself!
Follow these steps to install the CB as a base station.
4.Connect the CB’s red wire to the posi- tive (+) terminal on the DC power sup- ply.
5.Connect the DC power supply to a stan- dard AC outlet.
Cautions:
•To comply with FCC RF exposure com- pliance requirements, maintain a dis- tance of at least 20 cm between this device’s antenna and all persons.
•To prevent damage to the CB, be sure you connect an antenna and the micro- phone before you use the CB.
Note: Installation instructions are for satisfy- ing FCC RF exposure compliance.
Red wire to 
positive termi- nal of DC pow- er supply.
Antenna wire
Black wire to negative termi- nal of DC power supply.
1.Mount the base station antenna as described in its owner’s manual.
2.Connect the antenna to ANTENNA.
3.Connect the CB’s black power wire to the negative
8 |
| Installation | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
