take off-road should give you

Fig.2

a minimum standover height

 

clearance of

two inches

 

(5cm). A bike that you’ll ride

 

on unpaved surfaces should

 

give you a minimum of three

 

inches (7.5cm)

of standover

 

height clearance. And a bike that you’ll use off road should give you four inches (10cm) or more of clearance.

!WARNING: If you plan to

use your bike for jumping or stunt riding, read Section 2.F again.

B. Saddle Position

Correct saddle adjustment is an important factor in getting the most performance and comfort from your bicycle. If the saddle position is not comfortable for you, see your dealer.

The saddle can be adjusted in three directions:

1.Up and down adjustment. To check for correct saddle height (fig. 3):

sit on the saddle;

place one heel on a pedal;

rotate the crank until the pedal with your heel on it is in the down position and the crank arm is parallel to the seat tube.

If your leg is not completely straight, your saddle height needs to be adjusted. If your hips must rock for the heel to reach the pedal, the saddle is too high. If your leg is bent at the knee with your heel on the pedal, the saddle

is too low.

Once the saddle is at the correct height, make sure that the seatpost does not project from the frame beyond its “Minimum Insertion” or “Maximum Extension” mark (fig. 4).

If your bike has an interrupted seat tube, as is the case on some bikes with rear suspension, you must also make sure that the seat post is far enough into the frame so that you can touch it through the bottom of the interrupted seat tube with the tip of your finger without inserting your finger beyond its first knuckle (see fig. 5).

!WARNING: If your seat post projects from the frame beyond the Minimum Insertion or Maximum Extension mark (see fig. 4) or you cannot touch the bottom of the seat post through the bottom of the interrupted seat tube with the tip of your finger without inserting your finger beyond its first knuckle (see fig. 5), the seat post may break, which could cause you to lose control and fall.

2.Front and back adjustment. The saddle can be adjusted forward or back to help you get the optimal position on the bike. Ask your dealer to set the saddle for your optimal riding position and to show you how to

13

Page 13
Image 13
Raleigh None manual Saddle Position, Use your bike for jumping or stunt riding, read .F again