Rangemaster 63000EX MOUNT HOOD TO SUPPORT FRAME, WIRING

MOUNT HOOD TO SUPPORT FRAME

1.Insert four (4) bolts through the top of the hood - from the inside.

2.Use four (4) nuts to secure hood to support frame as shown.

NUT

BOLT

WIRING

Note: This range hood must be properly grounded.The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes.

Connection between Hood and exterior blower:

1.Remove the wiring box cover (A). Remove a knockout from the wiring box.

2.Feed 6" of power cable through the knock- out opening and secure cable to the wiring box with an appropriate connector.

3.Make electrical connections and connect the wires (see instructions in the exterior blower).

4.Replace wiring box cover and screws. Make sure that wires are not pinched between cover and box.

Electrical connections:

1.Remove the wiring box cover (B). Remove a knockout from the wiring box.

2.Feed 6" of power cable through the knock- out opening and secure cable to the wiring box with an appropriate connector.

3.Make electrical connections. Connect white to white, black to black and green to green.

4.Replace wiring box cover and screws. Make sure that wires are not pinched between cover and box.

Connection the hood to the

exterior blower

Exterior blower

WIRING BOX COVER (A)

WIRING BOX COVER (B)

- 6 -