INSTALLING THE CHIMNEY HOOD
COMPONENTS
The chimney hood comprises of the following: -
No 1 150x120mm ducting spigot (A) No 1 125x120mm ducting spigot (D) No 1 Splashback (B) optional
No 1 Canopy (C)
No 2 Recirculation grilles (G) No 1 Lower chimney stack (I) No 1 Recirculation ducting (P)
No 2 Recirculation extension ducts (P1) No 1 Recirculation spigot (R)
No 1 Upper chimney stack (S) No 2 Chimney fixing brackets (2)
Please ensure when the appliance is fitted it is easily accessible to an engineer in the
event of a breakdown.
All installations must comply with D local authorities requirements for
the discharge of exhaust air.
Incorrect installation may affect the
safety of this chimney hood.
INSTALLATION REQUIREMENTS
Before installation check the wall to which the hood is to be fitted for electric cables, gas and water
pipes.
This chimney hood is designed to be fixed to any vertical surface over a cooking area, and can be used in the extraction (ducted to the outside) or recirculation mode.
The installation work must be undertaken by a qualified and competent person.
RANGEMASTER Consumer Products disclaims any responsibility for damage due to incorrect installation of the chimney hood or if the hood is not installed in compliance with relevant regulations controlling this type
of installation.
10