Rangemaster ELTSHDC110SG Fitting The Telescopic, Chimney, after the chimney has been installed

INSTALLING THE CHIMNEY HOOD

by pressing it downwards until the two pieces meet.

3. Connect the two recirculation extension ducting pipes P1 on to the outlets on

either side of the spigot R, which push
fit into position, by pressing them
horzontally until the two pieces meet.	2.1

4.Do not fit the recirculation grilles until

after the chimney has been installed.	2
	8b

FITTING THE TELESCOPIC	2.2
CHIMNEY
The chimney stack consists of two sections.
1. To fit the upper chimney section S, first
apply pressure to expand the two side

panels slightly to allow the chimney to be fitted around the two brackets 2 as illustrated opposite. Fix the chimney to the two brackets 2 using four of the screws provided with the fixing kit.

2.To fit the lower chimney section I, first apply pressure to expand the two side panels slightly to allow the chimney to be fitted around the upper chimney S and the canopy C as illustrated opposite. Fix the chimney to the canopy C using two of the screws provided with the fixing kit.

3.To fit the two push-fit recirculation grilles G, insert them one at a time into the holes on either side of the chimney and apply slight pressure until they snap into position. Ensure the grilles are fitted correctly with one arrow pointing

upwards and one forwards.

4.When the hood is installed in the recirculation mode, ensure the recirculation grilles G, are properly secured to the inside of the recirculation ducting as illustrated opposite.

7.2.1

12c

8a

12c

14