Rangemaster RGG60 Electrical Connections, Hotplate, Customer Care, 3A fuse, ‘ASTA’ approved to BS

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Fig.5-4

�������

�����

������

�������

������� ArtNo.317-0012 - Hob fittings 1

�����

Electrical Connections

���This appliance must be installed by a qualified electrician to comply with the relevant Institute of Electrical Engineers (I.E.E.) regulations and also the local electricity supply company requirements.

 WARNING: THIS APPLIANCE MUST BE EARTHED

Note: All external wiring must comply with the IEE

��������� Regulations for the Electrical Equipment of Buildings.

�����Connection to the electrical supply can be made with either a plug and socket, or be permanently wired via a double pole switch. The hob is supplied with a 3-core cable, 900mm long.

���If a replacement cable is fitted it must be 250V high temperature PVC (85°C), 1 mm² minimum conductor size.

		Plug Connection
		For a plug connection a three-pin plug to BS 1363 with a
		capacity of not less than 13A must be used and fitted with a
�������	���������	3A fuse, ‘ASTA’ approved to BS 1362.
	�����	After replacing the fuse the cover must be refitted. If the
		cover is lost, the plug must not be used until a replacement
		cover has been obtained from your supplier. The colour of the
		correct fuse carrier is that of the coloured insert in the base of
		the fuse recess, or stated elsewhere on the plug. Always state
		this colour when ordering a replacement fuse carrier.
		IMPORTANT: The wires in the mains lead are coloured in
		accordance with the following code:
		Green and yellow:	Earth
		Blue:	Neutral
		Brown:	Live

Hotplate

Check each burner in turn. There is a spark ignition system that works when the knob is pressed in. Each burner also has a special safety device that stops the flow of gas if the flame goes out.

Push in and turn a control knob to the large flame symbol [s].

Keep holding the knob pressed in to let the gas through to the burner for few seconds. The igniter should spark and light the gas.

If, when you let go of the control knob, the burner goes out, the safety device has not held in. Turn the control to the OFF position and wait one minute, then try again this time holding in the control knob for slightly longer.

Customer Care

Please complete your contact details in the front of this section. Please inform the user how to operate the hotplate and hand over the instruction pack.

Thank you.

10