Electrical Supply Connection

Your refrigerator is intended as a permanent

nn

installation.

Connect the appliance to the electrical supply (220–240V ~ 50 Hz) with the plug and lead, which are fitted.

Connections to the mains supply should be in accordance with local regulations.

nnWarnInG: tHIs aPPlIance MUst Be eartHeD

All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. The appliance is supplied with a 3-core cable 2 m long. If a replacement cable is fitted it must be 250V high temperature PVC (85 °C), 1 mm².

Should the plug not fit the socket in your home, it should be removed and replaced with a suitable plug.

note: If the plug is fitted is not suitable, it must be cut off and disposed of properly. To avoid the risk of electrocution, the plug must not be left where children might find it and plug it into a supply socket.

Three pin plugs to BS 1363 with a capacity of not less than 13 A must be used and fitted with a 13 amp fuse ‘ASTA’ approved to BS 1362.

You MUST refit the cover after replacing the fuse. If the cover is lost, the plug MUST NOT be used until a replacement cover has been obtained from your supplier. The colour of the correct fuse carrier is that of the coloured insert in the base of the fuse recess, or stated elsewhere on the plug. Always state this colour when ordering a replacement fuse carrier.

IMPortant: The wires in the mains lead are coloured in accordance with the following code (fig.4-19):

Green and yellow:

EARTH

Blue:

NEUTRAL

Brown:

LIVE

Neutral: to the terminal marked N, coloured Blue

Earth: to the

fig.4-19

terminal marked E, coloured Green/Yellow

Live: to the terminal marked L, coloured Brown

15

Page 17
Image 17
Rangemaster U110122-01B Electrical Supply Connection, Your refrigerator is intended as a permanent Installation, Blue