Raymarine Ray48 manual Typical Mounting Methods, Typical Mounting Method Flush Mounting

•The transceiver should be located as near to the power source as possible.

•The selected location should be as far apart as is possible from any devices that may cause interference such as motors, generators, and other on board electronics.

•Generally speaking, the transceiver should be protected from prolonged direct exposure to rain and salt spray. It is always a good practice to protect your valuable electronic equipment as much as possible.

•Use adequately sized wire for all DC power connections and make sure to solder all in-line connectors or splices.

2.3.1Typical Mounting Methods

The Ray48 can be conveniently mounted on a chart table, bulkhead, overhead, or any other desired location (refer to Figure 2-1 for typical mounting methods).

CAUTION

Make sure there are no hidden electrical wires or other items behind the desired location before proceeding. Check that free access for mounting and cabling is available.

Fig.2-1 TYPICAL MOUNTING METHOD

2.3.2 Flush Mounting

In addition to the typical Mounting Methods, the Ray48 may also be flush mounted using the optional Flush Mount Kit (E46034). This kit is available from Raymarine Customer Service or your local Raymarine dealer.

3