Raypak 0133-4001 manual For Your Safety Read Before Operating, Operating Instructions

LIGHTING INSTRUCTIONS FOR HEATERS WITH ELECTRONIC IGNITION (IID)

FOR MODELS WITH MANUAL GAS VALVES

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because

some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

*Do not try to light any appliance.

*Do not touch any electric switch.

*Do not use any phone in your building.

*Immediately call your gas supplier from your neighbor’s phone. Follow the gas supplier’s instruc- tions.

*If you cannot reach your gas supplier, call the fire de- partment.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

OPERATING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Set the thermostat on the lowest setting.

3.Turn off all electric power to the appliance.

4.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

5.Remove heater door panel.

6.For Robertshaw gas valve: Turn gas control knob

clockwise to “OFF”.

For Honeywell Gas Valve: Turn gas control knob clock-

wise to “OFF". Make sure knob rests against stop. For Honeywell Gas Valve: (Model 400 only)

Push in gas control knob slightly and turn clockwise

to “OFF”. Knob cannot be turned to “OFF” unless knob is pushed in slightly. Do not force.

7.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information previously stated. If you do not smell gas, go to the next step.

8.For Robertshaw Gas Valve: Turn gas control knob

counter-clockwise to “ON”.

ROBERT SHAW

GAS CONTROL

KNOB SHOWN

IN "ON" POSITION

GAS INLET

Fig. # 8080

For Honeywell Gas Valve: Turn gas control knob counter-

clockwise	from “OFF” until it stops. Push in gas control
knob and continue rotating counter-clockwise		to “ON”
position. Make sure knob rests against stop.

HONEYWELL

GAS CONTROL

KNOB SHOWN

IN "ON" POSITION

GAS INLET

Fig. # 8082

9.Replace heater door panel.

10.Turn on all electric power to the appliance.

11.Set thermostat to desired setting.

12.If the appliance will not operate, follow the instructions “To Turn Off Gas To Appliance” and call your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

1.	Set the thermostat to the lowest setting.	For Honeywell Gas Valve: Turn gas control knob clock-
2.	Turn off all the electric power to the appliance if service	wise	to “OFF”. Make sure knob rests against
	is to be performed.	stop.

3.Remove door panel.

4. For Robertshaw Gas Valve: Turn gas control knob 5. Replace heater door panel.

clockwise to “OFF”.

32