CONTENTS
Warnings
Pay Attention to These Terms
Receiving Equipment
General Specifications
Installation
Mounting the Assembly
Wiring a Power Vent Assembly to an Appliance with IID Ignition Venting
Wiring Diagrams
182-260 H4/WH1 (Atmospheric)
330-400 H4/WH1 (Atmospheric)
Sequence of Operation
Start Up Procedures
Draft Proving Switch
Illustrated Parts List
3
3
4
4
4
4
7
7
9
9
10
11
12
14
14
14
15
WARNINGS
Pay Attention to These Terms
| DANGER: |
| Indicates the presence of immediate hazards which will cause severe |
|
|
|
| ||
|
| personal injury, death or substantial property damage if ignored. |
| |
| WARNING: |
| Indicates the presence of hazards or unsafe practices which could cause |
|
|
| severe personal injury, death or substantial property damage if ignored. |
| |
| CAUTION: |
| Indicates the presence of hazards or unsafe practices which could cause |
|
|
| minor personal injury or product or property damage if ignored. |
| |
| NOTE: |
| Indicates special instructions on installation, operation, or maintenance which |
|
|
| are important but not related to personal injury hazards. |
|
NOTE: Minimum 18 AWG, 105°C, stranded wire must be used for all low voltage (less than 30 volts) external connections to the unit. Solid conductors should not be used because they can cause excessive tension on contact points. Install conduit as appropriate. All high voltage wires must be the same size (105°C, stranded wire) as the ones on the unit or larger.
3
