Raypak D2 manual Tabs Before After

7.Mount the Power Vent on the outer top.

8.Route the conduit harness of the Power Vent thru the outer top hole, around the adapter towards the back of the unit. Continue routing the harness thru the corner slot, which leads to open area behind the access panel. Finally, route only the wire harness thru the 7/8” grommet hole located on the sway brace. Follow instructions on page 7 to wire the Power Vent. Note: Newer units have a 7/8” grommet located on the rain shield, which would eliminate routing the harness around the back corner.

9.Re-mount the jacket top to its original position and screw in the four screws holding it down to the appli- ance.

10.If the appliance is a 181, 182, 330 or 331, remove the tabs underneath the power vent using a 5/16” nut driver and relocate them closer to the center of the Power Vent as shown in Fig. 1.

11.Mount the Power Vent assembly bottom on the 6” vent as shown below. Twist the assembly downward. Snap the mounting brackets into their appropriate slot

TABS

BEFORE AFTER

Fig. 1: Reposition the Tabs as Necessary (see step 10)

to hold the Power Vent in position. Note: While twisting you may notice some roughness, this is due to a tight seal between the 6” vent and the Power Vent flue box.

12.Re-mount the access panel.

13.Re-mount the front door along with the knurled screw on the heater.

EXHUAST		TOP VIEW
	OUTLET

REAR VIEW LEFT SIDE FRONT VIEW

Note: The 90° elbow may be used as a termination cap.

Fig. 2: Draft Assembly

6