not push in or turn by hand, do not try to repair it, call a qualified service technician. Force or at- tempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above.
2.Set the thermostat on the lowest setting.
3.Turn off all electric power to the appliance.
4.Remove boiler door panel.
5.Push in gas control knob slightly and turn clock-
wise 
to “OFF”.
GAS CONTROL KNOB SHOWN IN "OFF" POSITION
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION
GAS INLET 
Fig. # 8081
Fig. # 8243.0
NOTE: Knob cannot be turned from “PILOT” to “OFF” unless knob is pushed in slightly. Do not force.
6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to the next step.
7.Locate pilot mounted on the burner drawer.
8.Turn knob on gas control counter clockwise
to “PILOT”.
THERMOCOUPLE
PILOT 
BURNER
Fig.# 8083
9.Push in control knob all the way and hold in. Immediately light the pilot with a match. con tinue to hold the control knob in for about one (1) minute after the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it
goes out, repeat steps 5 through 9.
*If knob does not pop up when released, stop and immediately call your service technician or gas supplier.
*If the pilot does not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
10.Stand to the side of the boiler and turn the gas
control knob counter clockwise | to “ON”. |
11.Replace boiler door panel.
12.Turn on all electric power to the appliance.
13.Set the thermostat to the desired setting.
TO TURN OFF GAS TO APPLIANCE
1.Set the thermostat to the lowest setting.
2.Turn off all electric power to the appliance.
3.Remove boiler door.
4.Push in the gas control knob slightly and turn
clockwise to 
"OFF". Do not force.
5. Replace boiler door panel.
BOILERS WITH AUTOMATICALLY LIT IID PILOTS AND MANUAL GAS VALVES
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.BEFORE OPERATING Smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
*Do not try to light any appliance.
*Do not touch any electric switch:
do not use any phone in your building.
*Immediately call your gas supplier from a neighbor's phone, follow the gas supplier's instructions.
*If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repir it, call a qualified service technician.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service
4
