![](/images/new-backgrounds/1104233/10423327x1.webp)
SECURING THE TOP PANEL COVER
INDOOR KIT ONLY
7.Reinstall the louvered top.
8.Mount the draft hood onto the adapter plate lip inside the heater. See Fig. 6.
9.Proceed to installing the clips, step 14.
SECURING THE TOP PANEL COVER
OUTDOOR KIT ONLY
10.After removing the drafthood from the box, slide the top panel cover over the draft hood. See Fig. 1.
11.Holding both pieces together, mount the draft hood on the adapter plate lip inside the heater. See Fig. 6.
12.Take the two pieces of tape and attach to each side of the drafthood leaving 6" hanging down.
13.Slide the top panel cover up and attach the tape to the underneath side. This is to temporarily keep the top panel cover out of the way while you are attaching the clips as shown in the next steps. See Fig. 7.
INSTALLING THE CLIPS
INDOOR & OUTDOOR KITS
14.Notice that there are three pilot holes above the base of the drafthood as shown in Fig.8. These are the locations where the three clips are to be attached.
15.Insert the long edge of one clip between the top panel cover and the drafthood, see Fig. 9.
16.With a twisting motion, rotate the clip up, see Fig. 10.
17.Pull up on clip, see Fig. 11.
18.Hold the clip up and align the clip hole to the pilot hole, see Fig. 12.
19.Insert screw into hole and secure using a 5/16" nut driver.
20.Repeat steps
21.This completes the indoor drafthood installation. If installing an outdoor drafthood, proceed to step 13.
14