Razor 13014940, 13014961 Set-Up and usage, Assembling the Handlebars, Assembling the Rear Wheels

Set-Up and usage

qAssembling the Handlebars

Tools Needed: 10 mm wrench

1 Align the holes on the handlebars and the T-bar. Insert handlebar bolts	2 Place the handlebar pad over the
into the top of the handlebar and through the T-bar. Install the washers and	handlebars and secure tightly with
nuts onto the bottom of the handlebar bolts. Tighten securely into place	the velcro cover.
using a 10 mm wrench.

qAssembling the Rear Wheels

Tools Needed: Two (2) 10 mm wrenches

3-3 3-1

3-2

3-5

3-5Frame

3-2

Note: For further assistance, please refer to page 5 for parts breakdown.

Rear wheel hardware sequence

3-1 - Locknut

3-2 - Spring washer

3-3 - Washer (small)

3-4 - Axle bolt

Wheel

3-5 - Washer (large)

3-1

3-4

3-3

1 Remove the locknut, spring washer and washers (x3) from one side of the axle bolt. Insert the axle bolt through the rear wheel. Insert the large washer (3-5) onto the axle bolt between the frame and rear wheel and slide the axle bolt through the frame. Slide the other large washer and wheel onto the axle bolt. Note: Wheels are interchangeable.

2 Insert the small washer (3-3), spring washer (3-2) and locknut (3-1) onto	3 Make sure the locknut, spring
the axle bolt and tighten securely using two (2) 10 mm wrenches.	washer and small washer are securely
	tightened against the wheel.

3